I
If the receiver looses signal from the transmitter does the DMX channels on the receiver stay at what they last received or do they go to zero or full? Is City Theatrical wireless gear compatible with WDMX or CRMX? I am having connection issue with my DMXCat to Samsung Galaxy A9 with Android 10. I am having connection issue with my DMXCat to Samsung Galaxy A9 with Android 10. Is a boom Tie off (1310) rated? I’m having trouble setting the multiverse show ID using RDM. When I access the device’s RDM parameters, there is no parameter displayed for show ID when using the Swisson RDM controller. I have tried all the connection issue FAQs and am still unable to connect my DMXCat 6000 to my device. What next? Is the ColorSource Relay compatable with the 5910 or 5902 or 5900? If I'm not using the 2nd radio at all, is there away of completely disabling it? If I just need 2 universes, is it better to use 1 radio in 2 universe mode, or both radios in 1 universe mode? I would like to use my 5900/5902/5903/5910/5911 with my new Multiverse QolorPoint 7000. How do I get the two to connect in the 2.4 range? Is there any issue with plugging the DMXCat 6000 into a receptacle and using it as the primary DMX controller as a permanent installation? I have my Multiverse Transmitter 5910/5911/5912 plugged directly in via the ethernet port to my ETC console. When I power on the console I lose control of my Multiverse Transmitter and I have to power cycle the Transmitter. What can I do to prevent this from happening? Is the DMXCat 6000 compatible with Lumenpulse? I can't factory default my 5910/5911/5912. Is the SHoW Baby system compatible with the LumenRadio CRMX system installed in the Ayrton Diablo Fixture? Is solid or stranded wire ok to use with the 5916/5917 I would like my 5942/5943 dimmer to act as an on/off switch for my Lava Lamp. How would you recommend accomplishing this? I attempted to update the firmware on my Multiverse Node 5902/5903 and received an error failed on one of the steps. What should I do? I want to use a 12V LED bulb with my 5942/5943 dimmer. What settings do I need to make this functional? Is my Multiverse QolorPoint compatible with legacy SHoW IDs? Is my CHAUVET PROFESSIONAL WELL Fit Wash LED Uplight Fixture compatible with Show Baby? I want to use two antennas on my one transmitter. How will this affect me? I want to be able to identify each receiver from a distance. Is there a way to do this? I am using the QolorFlex 2x5A Show DMX Neo Dimmer (Legacy Version) what do the different curves do? Is there a way to lock the SHoW ID settings to avoid accidental presses on my QolorPoint?