C

• Can I change the name of my DMXCat?
  Once connected to your DMXCat go back to the connect to device page and you can rename the device you are actively connected to. ...
• Can I use my DMXCat while it is charging?
  Yes, you can use your DMXCat while it charges! ...
• Can I share my fixture profiles in DMXCat
  Yes, you can. Sharing Setup Via Cat Yes, it is possible, but currently, due to some Android restrictions, it is a bit convoluted if you (or ...
• Can the Track Tamer be used in a horizontal position?
  No, our Track Tamers are used only in a vertical orientation. City Theatrical does not approve or support Track Tamers being used in the horizontal ...
• Can I mount my GLP-X4XL-CR with a diffuser?
  Yes, GLP-X4XL-CR is to be mounted with a diffuser. ...
• Can I mount GLP-X4XL-LH with a diffuser?
  No, GLP-X4XL-LH is to be mounted without a diffuser. ...
• Can I mount 6377 with a diffuser?
  No, 6377 is to be mounted without a diffuser. ...
• Can my 5902/5903 be used as a DMX Port to communicate to my wired fixtures?
  Yes, you can use the DMX out to continue any DMX runs as needed. If the DMX in port is connected you receiver will become ...
• Can I run the DMXcat app on my Nintendo Switch?
  Currently, that is not possible, but we will take it under consideration for a future release. ...
• Can my 5902/5903 be used as a transmitter?
  Yes! Simply connect a DMX cable to the DMX In port on the bottom of the device and it switches to transmit mode. You can ...
• Can I change the SHoW ID using a Swisson RDM device?
  The SHoW ID parameter is a manufacture specific parameter. Unfortunately, the Swisson device does not support manufacture specific parameters. You will need to use an ...
• Can I pass DMX thru the DMX Iris 2192?
  No, you can not pass DMX thru the DMX Iris. The unit only receives DMX. ...
• Can I have two DMX cables coming out of the Vero (7400-5902/5903)?
  If the Vero is operating in Transmit mode, Yes, just make sure you have termination off in the settings menu.If the Vero is operating in ...
• Can I use my Orange Show Baby with my 5910 Multiverse Transmitter?
  No, orange Show Babies are not compatible with the 5910 Multiverse Transmitter. You will need to use the legacy Show IDs with a Show Baby ...
• Could I have more than one DMXCat 6000 connected to the same phone if there are multiple locations?
  You can only have one DMXCat 6000 connected to one device at a time. ...
• Can I pass through data on my 2192?
  No, the DMX Iris can not pass thru data. ...
• Can my 5910/5911/5912 be power off remotely via POE?
  No, this is not possible at this time. ...
• Can I RDM into my Multiverse products via a ColorSource Console?
  Yes, the ColorSource Console line supports RDM discovery. Please contact ETC for further instruction. ...
• Can I paint my Yagi 5982 and/or Panel 5981 antenna?
  Yes, you can as long as you do not use metallic paint. ...
• Can I get the specific frequencies for Show Baby Neo SHoW IDs?
  201 Green – Adaptive Hopping 2.40GHz – 2.480GHz102 Cyan – Full spectrum 2.40GHz – 2.480GHz 117 Magenta – Low, Wi-Fi 1-6 2.40GHz - 2.448GHz 133 ...
• Can PN 4305, ETC Source 4 LED CYC Floor Base, be used with the ETC Series 3 fixture?
  Yes, 4305, the ETC Source 4 LED CYC Floor Base is compatible with all standard ETC Source 4 LED fixtures. ...
• Can I put boiling water in the tank to start with?
  This is not recommended and can cause damage to the unit. Waters boiling point is 212F and the unit should not go past 160F ...
• Can I use a Show Baby as both a transmitter and as a dmx Through to continue the DMX chain? (Both at the same time)
  Yes when the Baby is used as a transmitter, the female connector is a pass-thru. ...
• Can I use the Multiverse Show Baby 5900 in the 900Mhz range?
  No, the 5900 is only compatible with the Legacy Show IDs and the 2.4Ghz range. ...
• Can you explain how to use the Flicker Finder feature?
  The Flicker Finder you will need to output a static DMX signal through the DMX line. Then place the DMXCat in the DMX line, open ...
• Can the shaft going from the motor to the flag be longer?
  No, it only comes in one standard size. ...
• Can I lock the keypad of my QolorPoint 7000?
  Yes! The keypad may be locked to prevent tampering or inadvertent adjustment of the unit.Hold down the FN first then turn on, after a couple ...
• Can my studio receiver be used as a transmitter?
  No, the studio receiver is only intended to be a receiver. ...
• Can my receiver card be used as a transmitter?
  Yes, please reach out to support for further instructions. ...
• Can my RadioScan show me where the SHoW IDs are in the 2.4 and 900 range?
  Yes, there is a Multiverse SHoW ID button at the top of the application that will bring up a right side bar and you can ...
• Can I take a screenshot or video of the scan?
  Yes, you can take a screenshot with the 'Snapshot' feature or a video by selecting the 'Save' button. Snapshot will allow you to save an ...
• Can I order replacement parts for my Candle?
  The candle is a legacy product we no longer supply parts for. Stock is limited and low for replacement parts. Reach out to support to ...
• Can I run a motor from my 5809?
  The unit may burn out so we recommend putting a reverse-biased diode in line to help with avoiding burning out the dimmer. ...
• Can the Flag be larger?
  We only sell one size. This would be a custom request if the customer needs a different size flag. ...
• Can I perform repairs on my DMX Iris 2192?
  There are no user-serviceable parts inside! Refer to qualified servicepersonnel! ...
• Can I operate the candle over PWM
  The candles do not take PWM and will not work with the receiver cards. A dimmer such as the 5916/5917 or 5942/5943 will work. https://www.citytheatrical.com/products/electronics/qolorflex-dimmers/qolorflex-5x2.5a-multiverse-dimmerhttps://www.citytheatrical.com/products/electronics/qolorflex-dimmers/qolorflex-2x2.5a-multiverse-dimmer ...
• Can I control the City Theatrical Candle with my Receiver Card?
  The candles do not take PWM and will not work with the receiver cards. A dimmer such as the 5916/5917 or 5942/5943 will work. https://www.citytheatrical.com/products/electronics/qolorflex-dimmers/qolorflex-5x2.5a-multiverse-dimmerhttps://www.citytheatrical.com/products/electronics/qolorflex-dimmers/qolorflex-2x2.5a-multiverse-dimmer ...
• Can I use my legacy Show Baby with the Multiverse Vero?
  Yes, but you will be limited to the legacy SHoW ID range. ...
• Can I order custom QolorFLEX LED tape lengths?
  For custom lengths less then 5 meters, "CTL" should be substituted when ordering, and the desired pigtail configuration discussed with our sales department as is ...
• Can I use the 5917/5916 outside of the plastic enclosure?
  Yes, although to avoid damage we recommend leaving it in the plastic. ...
• Can I purchase replacement phoenix connectors?
  Yes, below are the available sizes. 5672 Terminal Block Connector, Three Pin, Female5674 Terminal Block Connector, Four Pin, Female58106611 Terminal Block Connector, Five Pin, Female58116613 ...