Advanced search

306 search results

Page 15 out of 31 Pages

• ColorSource Relay: What is the operating temperature of the ColorSource Relay?
  Answer: 0°C–40°C; 5–95% humidity ...
• Wireless Products General: Am I able to send fixture firmware updates via Multiverse Products?
  Answer: No, it is not possible to send fixture firmware updates via Multiverse products. ...
• DMXcat: Will my DMXCat 6000 automatically power down or will it stay on as long as
  Answer: The DMXCat 6000 will power down after 8 hours of nonuse. ...
• DMXcat: Is there any issue with plugging the DMXCat 6000 into a receptacle and using it
  Answer: The DMXCat 6000 is intended to be used as a test tool not as a controller. After 8 hours of nonuse the DMXCat will power ...
• DMXcat: Could I have more than one DMXCat 6000 connected to the same phone if there
  Answer: You can only have one DMXCat 6000 connected to one device at a time. ...
• Multiverse Transmitter: I have my Multiverse Transmitter 5910/5911/5912 plugged directly in via the ethernet port to my
  Answer: Try adding a switch between the console and the Multiverse Transmitter. This should eliminate the issue and allow you to power on the console without ...
• DMXcat: Is the DMXCat 6000 compatible with Lumenpulse?
  Answer: There is a known bug with a certain version of DMXCat software that will cause issues with RDM.  ...
• LED Tape: How do I wire the +, A-E for the LED Tape to my 5942/5943?
  Answer: The wires in A-E can vary but the one consistent is: + - Black cable Typical wiring is + - Black A - Red B ...
• DMX Iris: Can I pass through data on my 2192?
  Answer: No, the DMX Iris can not pass thru data. ...
• Multiverse Transmitter: What is the ambient temperature range for my 5910/5911/5912?
  Answer: Indoor - 0 C to 40° C ...

• ⇤
  
• ←
  
• 1
  
• 2
  
• 3
  
• 4
  
• …
  
• 13
  
• 14
  
• 15
  
• 16
  
• 17
  
• …
  
• 28
  
• 29
  
• 30
  
• 31
  
• →
  
• ⇥

The most popular searches are: